Pramet WNMG 433W-MR:T5315 6850896 Turning Insert - Negative
- Write a review
$11.75
ChipbreakerW-MRCoatingT5315Coating processMT-CVDCoating property (CTP)1Cooling effectPositive effect on tool life - cooling is recommendedCorner radius - inch (RE)0.047Corner radius - millimeter (RE)1.2Cutting edge length - inch (L)0.343Cutting edge length - millimeter (L)8.7Depth of cut maximum - inch (APMX)0.157Depth of cut maximum - millimeter (APMX)4Depth of cut minimum - inch (APMN)0.047Depth of cut minimum - millimeter (APMN)1.2Feed maximal - millimeter0.75Feed minimal - millimeter0.25Feed_MAX_IMP_NUM0.03Feed_MIN_IMP_NUM0.01Fixing hole diameter - inch (D1)0.203Fixing hole diameter - millimeter (D1)5.16Inscribed circle diameter - inch (IC)0.5Inscribed circle diameter - millimeter (IC)12.7Insert thickness - millimeter (S)4.76
Specifications
| Chipbreaker | W-MR |
| Coating | T5315 |
| Coating process | MT-CVD |
| Coating property (CTP) | 1 |
| Cooling effect | Positive effect on tool life - cooling is recommended |
| Corner radius - inch (RE) | 0.047 |
| Corner radius - millimeter (RE) | 1.2 |
| Cutting edge length - inch (L) | 0.343 |
| Cutting edge length - millimeter (L) | 8.7 |
| Depth of cut maximum - inch (APMX) | 0.157 |
| Depth of cut maximum - millimeter (APMX) | 4 |
| Depth of cut minimum - inch (APMN) | 0.047 |
| Depth of cut minimum - millimeter (APMN) | 1.2 |
| Feed maximal - millimeter | 0.75 |
| Feed minimal - millimeter | 0.25 |
| Feed_MAX_IMP_NUM | 0.03 |
| Feed_MIN_IMP_NUM | 0.01 |
| Fixing hole diameter - inch (D1) | 0.203 |
| Fixing hole diameter - millimeter (D1) | 5.16 |
| Inscribed circle diameter - inch (IC) | 0.5 |
| Inscribed circle diameter - millimeter (IC) | 12.7 |
| Insert thickness - millimeter (S) | 4.76 |
6850896
